ARB 3232200 - Manual (Page 18)

02-08-12 Page 18 of 23 3787827
52. Run the cables through the rubber
grommets and connect to the winch as
per wiring diagram supplied with the
winch.
53. Using cable ties, fix the cables away from
any moving, sharp or hot surfaces.
BULL BAR FITMENT TO VEHICLE
54. Fit the six M8 cage nuts to the impact
absorbers.
55. Mount both the impact absorbers to the
vehicle using four (a side) M8 x 25mm
bolts, M8 flat and spring washers in the
front face, two (a side) M10 x 35mm
bolts, M10 flat washers, M10 spring
washers and M10 flange nuts in the
underside.
( DO NOT TIGHTEN)
M10 bolts
Left hand side