Brother HE-800A - Manual (Page 30)

HE-800A
4. INSTALLATION
22
ዐ-ውዐ-ው. Changing the treadle unit installation position (horizontal positioning only)
Note: If the machine head is positioned horizontally, install the treadle unit to the motor.
1. Disconnect the connector (2) of the treadle unit (1) inside the control box.
2. Remove the screw (3), and then disconnect the ground wire. Then, re-tighten just the screw (3).
3. Remove the three screws (4), and then remove the treadle unit (1).
4. Install the V cord bushing (6) to the treadle setting plate (5).
5. Install the treadle setting plate (5) and the treadle unit (1) to the motor with the three screws (4).
6. Install the ground wire with the screw (7).
7. Re-connect the connector (2) of the treadle unit (1) inside the control box.
3893Q 3892Q
3891Q