Brother HE-800A - Manual (Page 33)

HE-800A
4. INSTALLATION
25
ዐ-ውዓ-ዎ. Lubricating the arm
Apply 5-6 drops of oil to the oil inlet (1) at the top of
the arm.
* When using the machine, check that the oil is visible
through the oil window (2). If it cannot be seen,
problems such as seizure of the mechanism may
occur.
ዐ-ውዓ-ዏ. Lubricating the rotary hook
When first installing the machine and when the
machine has not been used for an extended period of
time, remove the bobbin and add 2-3 drops of oil to
the rotary hook race (1) before sewing.
Rotary hook lubrication adjustment
1. Remove the rubber cap (2).
2. Turn the adjusting screw (3) to adjust the lubrication
amount.
* Adjust so that approximately 10 drops of oil are
released when the sewing machine is run at a
speed of 4,000 sti/min for three cycles to sew about
114 stitches. Use Kraft paper (4) or similar to catch
the oil drops. As a guide, the optimum position can
be obtained if the adjusting screw (3) is tightened as
much as possible and then loosened about two
turns.
3898Q
3899Q
3900Q
More
Less