Brother HE-800A - Manual (Page 64)

HE-800A
6. CHECKING THE SEWING PATTERN
56
ዒ-ዎ. Manual mode
1. Press the SELECT key (1) to change the mode to automatic mode.
2. Press the program No. keys (2) and (3) to select the number for the program to be checked, and then press the
ENTER key (4).
* The program number LED (5) will stop flashing and light steadily.
3. Press the SELECT key (1) to change the mode to manual mode.
* The number of stitches in the selected program will appear as "H***" in the parameter display LED (6).
4. Depress the treadle from the neutral position [A] to the 2nd step [C].
* The work clamp will be lowered, and the needle zigzag and feed mechanisms will move to the sewing start
position.
5. Turn the machine pulley by hand. The needle zigzag and feed mechanisms will each advance by one step each time
the machine pulley is turned.
* If the knife has been set to operate, the buzzer will sound and "C-On" will appear in the parameter display LED (6).
6. Stop turning the machine pulley when "H o" appears in the parameter display LED (6) and the pulley is at the
needle up stop position.
7. When the treadle is depressed once more to the 2nd step [C], the sewing machine will move to the home position,
and the work clamp will rise.
8. Press the SELECT key (1) to change the mode to automatic mode.
ƒ If you turn the machine pulley to the needle up stop position and press the SELECT key (1) during the checking
operation, the mode will change to test feed mode.
ƒ If you would like to stop checking before the operation has completed, press the RESET key (7). The sewing
machine will move to the home position, and the work clamp will move to the neutral position.
3947Q 3905Q