ዑ - ዔ . cutter operation – Brother HE-800A User Manual

Page 58

Advertising
background image

HE-800A

5. OPERATION

50

-. Cutter operation

The cutter operating pattern can be selected from the following four patterns.

Parameter No. 44

0 1 2 3

Operates when the front
tack of the last buttonhole
cycle is sewn.

Operates near the front
tack when sewing is
finished and material is
feeding.

Operates immediately
before the left zigzag stitch
of the last cycle is sewn.

Operates twice:
immediately before the left
zigzag stitch of the last
cycle is sewn and when
the front tack of the last
cycle is sewn.

Setting range 0:

General sewing

Setting range 1:

Because the needle and knife positions are separated

by 2.2 mm as shown in the illustration, the distance

between the edge of the front tack and the edge of the

buttonhole cannot be set to less than 2.2 mm.

For example, if the knife Y space (A) is set to 0.5 mm,

the front tack length (B) will not go below 1.7 mm. At

such times, the front tack length can be set to less

than 1.7 mm when using cutting after sewing.

Once sewing is finished and material feeding has

finished, the cutter will operate.

Setting range 2:

• Does not operate during the first sewing cycle. Only applies to second and subsequent cycles (during underlay

sewing and overlap sewing).

ƒ This is used in cases such as when the rough edges of the material after cutting are hemmed by the buttonhole

stitches.

ƒ The cutter operates before the left zigzag stitch of the last cycle is sewn.

Setting range 3:

• Does not operate during the first sewing cycle. Only applies to second and subsequent cycles (during underlay

sewing and overlap sewing).

ƒ This is used in cases such as when the rough edges of the material after cutting are hemmed by the buttonhole

stitches.

ƒ It can also be used if the rough edges of the material block the buttonhole after the left and right zigzag stitches have

been sewn.

• The cutter operates immediately before the left zigzag stitch of the last cycle is sewn, and it operates again when the

front tack of the last cycle is sewn.

3937Q

3936Q

3938Q

3935Q

3939Q

2.2 mm

Feeding

Advertising