Brother HE-800A - Manual (Page 43)

HE-800A
5. OPERATION
35
Example 3: How to copy the settings for program No. 3 to program No. 11.
Set parameter number 69 to "Copy source
program number setting value 3".
1. Press the SELECT key (1) to change the mode to
automatic, test feed or manual mode.
2. Press the program No. keys (2) and (3) to select
the program number 11, and then press the
ENTER key (4).
3. Press the SELECT key (1) to change the mode to
program mode.
4. Press the program No. keys (2) and (3) to select
the parameter number 69.
5. Press the parameter keys (5) and (6) to select the
parameter setting value 3, and then press the
ENTER key (4).
The parameters for program number 3 will then be
copied to the parameters for program number 11.
6. Press the SELECT key (1) to change the mode to
automatic mode.
ዑ-ዐ-ዎ. Checking the length of knife
1. Press the SELECT key (1) to change the mode to
automatic, test feed or manual mode.
2. Press the program No. keys (2) and (3) to select the
program number 11, and then press the ENTER
key (4).
3. Press the SELECT key (1) to change the mode to
program mode.
4. Press the program No. keys (2) and (3) to select the
parameter number 02 (length of knife).
5. Check that the length of the knife that is installed to
the sewing machine matches the knife length
setting that is being displayed in the parameter
display LED (5).
6. If the knife lengths are different, press the
parameter keys (6) and (7) until the knife length
setting matches the length of the knife that is
installed to the sewing machine, and then press the
ENTER key (4).
Note:
Be sure to change the knife length setting if the knife is replaced with a knife of a different length.
The stitch length will be automatically determined by the value for the length of the knife which has been set.
Therefore, if the knife length is not set correctly, problems may occur, such as the bar tacking stitches being cut by
the knife.
3917Q
3916Q
3918Q