IKA C 5000 control Package 2/12 - Manual (Page 76)

 'HWHUPLQLQJ JURVV FDORULILF YDOXHV
IKA  -WERKE C 5000 control/duo-control Ver. 10 04.07
3DJH 
g
The decomposition vessel is vented and the measurement cell cover opens.
h
As soon as the message %RPE n appears, remove the decomposition vessel and
open it.
i
Check the crucible for combustion residue. Both the cotton thread and the fuel sam-
ple must have been burned completely. If there are any signs of incomplete com-
bustion, the experiment must be repeated.
 &OHDQLQJ WKH GHFRPSRVLWLRQ YHVVHO
,I WKHUH LV DQ\ UHDVRQ WR VXVSHFW WKDW WKH FRPEXVWLRQ VDPSOH RU WKH FRPEXV
WLRQ UHVLGXH FRXOG EH KD]DUGRXV WR KHDOWK \RX VKRXOG ZHDU SURWHFWLYH SHU
VRQDO HTXLSPHQW ZKHQ KDQGOLQJ DQG ZRUNLQJ ZLWK WKHVH PDWHULDOV IRU H[DP
SOH SURWHFWLYH JORYHV JDV PDVN  ([SHULPHQW UHVLGXHV WKDW DUH KD]DUGRXV WR
KHDOWK RU ZKLFK DUH HQYLURQPHQWDOO\ KD]DUGRXV PXVW EH GLVSRVHG RI ZLWK VSH
FLDO ZDVWH :H PDNH H[SOLFLW UHIHUHQFH WR WKH DSSOLFDEOH UHJXODWLRQV
It is of fundamental importance for the decomposition vessel to be clean and dry.
Contamination can change the heat capacity of the decomposition vessel and result
in imprecise measurement results. After each combustion experiment, the inner
walls of the vessel, the inner fittings (supports, electrodes, etc.) and the combustion
crucible (inside and outside) must be thoroughly cleaned.
In most cases, condensation must simply be removed from the inner walls of the
vessel and the inner fittings. It is sufficient to carefully wipe off the parts with an ab-
sorbent cloth that will not leave lint.
If the decomposition vessel cannot be cleaned with the procedure described (for
example because of burned or corroded spots), you should contact the Technical
Service Department.
The combustion residue in the crucible, for example soot or ash, should also be
carefully wiped off with an absorbent cloth that will not leave lint.
8VHU
,QQHU ZDOOV RI
WKH YHVVHO
&UXFLEOH