Operator programming mode - (level-3), Operator programming mode - (level-3) -14 – JLG 15/20MSP Service Manual User Manual
Page 71
SECTION 4 - CONTROL COMPONENTS
3121231
– JLG Lift –
4-15
Operator Programming Mode - (Level-3)
In the Operator Programming Mode the following items
are shown on the main menu (also see Table 4-1):
• Tilt Sensor
• Program
NOTE: There are two production modules available at this
time, one for North/South American and European
languages, and one for Asian languages. All pro-
grammable items between these modules are identi-
cal with the exception of language selection.
Tilt Sensor
Allows viewing current tilt sensor individual X and Y direc-
tion degree reading.
Program
Allows the Operator to program Level-3 items shown in
Table 4-1 following.
Table 4-1. MVL/MSP Ground Control Module - Field Programmable Settings and Factory Preset.
Level-2: Service Level Settings
On LCD Display:
YES =
✓
HIGH =
↑
Level-3: Operator Level Settings
NO =
✕
LOW =
↓
LEVEL
PROGRAMMABLE ITEM
FACTORY PRESET
SETTING RANGE
2
Back to Main
15/20MVL/MSP
Return to Programming Menu
3
Set Language
NOTE: There are two production modules available,
one for North/South American and European
Languages, and one for Asian Languages.
1
1 - English
6 - Italian
2 - German
7 - Swedish
3 - Dutch
8 - Brazilian Portuguese
4 - French
9 - Finnish
5 - Spanish
2
1 - English
3 - Japanese
2 - Chinese
2
Set Maximum Lift Up Speed
100%
0 - 100%
2
Set Maximum Lift Down Speed
100%
0 - 100%
2, 3
Set Sleep Time
5 MINS
0 - 60 MINS
2
Set Polarity Of Left Pot Hole Input 1
2
0 - Disabled / 1 - LOW / 2 - HIGH
2
Set Polarity Of Right Pot Hole Input 2
2
0 - Disabled / 1 - LOW / 2 - HIGH
2
Set Polarity Of Up Limit/Elevation Input
HIGH
HIGH/LOW
2
Set Polarity Of Charger Inhibit
LOW
HIGH/LOW
2, 3
Set Polarity Of The Keypad Code
LOW
HIGH/LOW
2
Set Polarity Of Ancillary Input 1
LOW (a)
HIGH/LOW
2
Set Polarity Of Ancillary Input 2
LOW (b)
HIGH/LOW
2
Load Sensing (LSS)
OFF
ON/OFF
2, 3
Enable Detection Of Horn Open Circuit
NO
YES/NO
2, 3
Enable Detection Of Beacon Open Circuit
NO
YES/NO
2
Enable Obstruction Sensor System (OSS)
NO
YES/NO
2
Enable Detection Of Aux. #1 Open Circuit
NO
YES/NO
2
Enable Detection Of Aux #2 Open Circuit
NO
YES/NO
3
Forward Alarm Disable
NO
YES/NO
3
OSS Diagnostic
NO
YES/NO
2
Zero the On-Board Tilt Sensor
NO
YES/NO
3
View Tilt Sensor Readings
—
—
2
Brush Wear Sensor Timer Reset
—
BLANK/WORN
2
Ancillary 1 Input Inhibit
0
0 - 4
2
Ancillary 2 Input Inhibit
0
0 - 4