JLG 15/20MSP Service Manual - Manual (Page 74)

SECTION 4 - CONTROL COMPONENTS
4-18 – JLG Lift – 3121231
Display/Controller Module Electrical
Connections
The internal switches and joystick controller of the plat-
form console plug directly into the Display/Controller
Module. This module then relays the signals from these
switches to the Ground Control Box through the commu-
nications cable running to the platform junction box
mounted to the mast under the platform.
Mounting Bracket - Install/Remove
Rear Cover - Install/Remove
Platform Console - Circuit Board Connections
1. Horn Switch - (C5)
2. Communications Cable to
Platform Junction Box -
(C6)
3. ON/OFF Key Switch (C3)
4. E-Stop/Shut-Down Switch -
(C4)
5. Drive/Lift Mode Select
Switch - (C7)
6. Joystick - (C8)
Note: The (C) numbers shown after the description above repre-
sent the corresponding identification of the plug on the
module’s circuit board.
3
6
2
5
1
4
Platform Console - Mounting Bracket
1. Mounting Bracket 2. Bracket Screws (a)
Note: (a) Apply Loctite #242 to screw threads on final assembly.
Platform Console - Rear Cover Installation
1. Rear Cover 2. Cover Mounting Screws
1
2
1 2