JLG LiftPOD FS80 (1001070451) - Manual (Page 22)

SECTION 2 - PREPARATION AND INSPECTION
1001070451 LIFTPOD by JLG 1-877-254-3876
2-4 www.liftpod.com 1-877-2-LIFTPOD
Pre-Start Inspection
The Pre-Start Inspection should include each of the following:
1. Cleanliness – Check all surfaces for leakage, debris or
foreign objects.
2. Decals and Placards – Check all for cleanliness and
legibility. Make sure none of the decals and placards are
missing. Make sure all illegible decals and placards are
cleaned or replaced. (Reference Section 5.2, Decal
Installation).
3. Operation, Safety Service & Maintenance Manual –
Make sure a copy of the Operation, Safety, Service &
Maintenance Manual and ANSI Manual of Responsibili-
ties (U.S.A. only) is enclosed in the weather resistant
storage container.
4. Assembly – The machine must be fully assembled in
accordance with Section 3.3.
5. Walk-Around Inspection – Refer to Section 2.3.
6. Powerpack – Charge as required (Section 3.4).
7. Function Check – Once the Walk-Around Inspection is
complete, perform a function check of all systems in an
area free of overhead and ground level obstructions.
Refer to Section 2.4 for more specific instructions.
2.3 DAILY WALK-AROUND INSPECTION
Begin the Walk-Around Inspection at item one (1) as noted on the
diagram Figure 2-1. Continue around machine checking each item
in sequence for the conditions listed in the following check list.
TO AVOID POSSIBLE INJURY, BE SURE DIRECTION SELECTOR IS IN THE
“OFF” POSITION DURING WALK-AROUND INSPECTION.
DO NOT OPERATE MACHINE UNTIL ALL MALFUNCTIONS HAVE BEEN
CORRECTED.
NOTE: Do not overlook visual inspection of the base frame
underside. Check this area for objects, debris, corrosion
and cracks.
NOTE: The mast and carriage components should be clean and
free from oil, grease and dirt. Do not lubricate mast or car-
riage components, especially brake shoes.
FS.book Page 4 Tuesday, May 10, 2011 3:15 PM