2N Omega Lite - Installation Manual v1.5 - Manual (Page 27)

2N
®
- OMEGA Lite
Installation manual
Installation manual
27
www.2n.cz
5.9.
5.11. Module VoIP (Order No 1880021)
The VoIP Module is designed exclusively for 2N
®
OMEGA Lite PBXs as a VoIP
module for LAN and Internet voice services.
The VoIP Module is to be installed to the left from the power supply unit, above
the main board. To connect the module, use the two connecting cables packed in
the separate plastic bag (insert them to the J15/J26 connectors on the main board)
and the two spacers (also packed in the separate plastic bag). Use the remaining
two M3 screws to screw the VoIP Module to the spacers.
Remove the two J8/J9 links on the PBX base plate for appropriate operating
efficiency.
Use the USB cable and the hyper-terminal for the initial setting of the IP
address and the network mask; use the (available) web configuration for further
settings.
The system connects to the 10/100BASE-T (Twisted Pair Ethernet) computer
network through a standard direct cable with RJ 45 connectors at the end.
See the VoIP Module User Manual on the enclosed CD for detailed
installation information.
The following is located on the VoIP module:
J1
- RJ45 connector - 8/8 for LAN connection.
J2 - USB connector for USB connection, designed for IP configuration.
J4,J8 - serial connector designed for connection with the main board of the PBX.