2N Omega Lite - Installation Manual v1.5 - Manual (Page 28)

2N
®
- OMEGA Lite
Installation manual
Installation manual
28
www.2n.cz
J3 - connector for the connection of adapter for an external USB device (module
UMTS-3G).
J5-J7 - connector for maintenance use
J9
- connector for connection of a functional floor*
SW2 - RESET button. Pressing this button will RESET the CPU board.
SW1 - RESET button. Pressing this button will reset default values (after switching
on the PBX hold the button pressed for approximately 20s until LINUX starts).
D1
- green LED – operation status indication (VoIP module ready for operation,
approximately 20s after light-up).
D2
- red LED – operation status indication (VoIP module inactive).
D3-D10 - yellow LED – call channels busy signal.
* In preparation
Detailed installation
6.1. Selection of place for PBX
Aspects which must be taken into consideration when selecting a place for the PBX:
•
Good visibility and accessibility (the exact time and other data about operation is
shown in the display of the PBX in operation).
•
Protection from damp and extreme temperatures: the PBX must definitely
not be located near heat sources (above heaters) or in a place where direct
sunlight may fall. Also avoid damp places (bathroom, cellar), places where
the temperature changes rapidly (near doors, windows, air-conditioning),
dusty places (workshops etc) or places with aggressive gases (battery
rooms, boiler rooms) and places with high vibrations and shocks
(compressors, heavy industrial operations). The PBX has an upright
operating position.
•
Installing circuits in building: by choosing a suitable location for the PBX (centre
of building or administrative centre) it is possible to reduce the costs for the
building of the circuits. If there are already circuits in the building, the location of
the PBX is generally already determined thereby and it cannot be changed.
•
Possibility of direct connection using modules with connectors RJ-45.
•
Quality of GSM signal: if one part of your configuration is (or later will be) a GSM
module, it is necessary to take into account the fact that the cable from the PBX
to the GSM cable is usually about 3 metres long (maximum 10m). It is therefore
necessary to make sure that in the specified circuit around the selected place for
the PBX there is a place with a good level of GSM signal suitable for locating the
GSM antenna. *)
•
Ensuring against theft: when selecting a position, it is recommended that the
conditions of the insurance company be respected.
•
Opening cover: there should be at least 10 cm of free space right and left of the PBX.