2N Helios IP Configuration Manual v2.8.1 User Manual
Page 82
82
a.
b.
c.
d.
Sender – enter the sender's E-mail.
Default recipient – typically, the intercom sends E-mail messages to the user
addresses included in the Phone Book. If the Phone Book E-mail parameter is not
completed, the messages are sent to the address included in this parameter. If a
user is not included in the Phone Book or this field, no E-mail is sent.
Message subject – set the E-mail subject to be sent.
Message body – edit the text to be sent. Use the HTML formatting marks in the
text. You can insert special symbols substituting the username, date and time,
intercom identification or called number, which will be replaced with the actual
value before sending. Refer to the table of substitute symbols below:
$User$ Called username
$DateTime$ Current date and time
$DialNumber$Called number
$HeliosId$ Intercom identification
Attach snapshots – enable sending of an attachment including one or more
camera snapshots taken during ringing or calling.
Number of snapshots – set the count of snapshots to be attached to the E-mail
message.