2N Helios IP Configuration manual v2.6 - Manual (Page 37)

37
2N TELEKOMUNIKACE a.s., www.2n.cz
®
Activation by quick dial button – assign a quick dial button to the switch. The
switch is activated whenever the button is pressed.
Sound signalling – set the sound signalling type for switch activation. Choose
the Short beep, Long beep (during the whole activation) or a User sound (refer to
the User Sounds subsection).
Display info – enable/disable signalling of an activated switch on the display.
Synchronise with – set switch synchronisation to enable automatic switch
activation after another switch activation with a predefined delay. Define the
delay in the
parameter Synchronisation delay
Synchronisation delay – set the time interval between synchronised activations
of two switches. The parameter will not be applied if the
function is Synchronise
disabled.
Command sent upon activation – set the command to be sent to the external
device (WEB relay, e.g.) upon switch activation. The command is sent via the
HTTP (GET request) and must be as follows: http://ip_address/path. E.g.:
. http://192.168.1.50/relay1=on
Command sent upon deactivation – set the command to be sent to the
external device (WEB relay, e.g.) upon switch deactivation. The command is sent
via the HTTP (GET request) and must be as follows: http://ip_address/path.
Note
The HTTP command sending is available with the Gold or Enhanced
Integration licence only .