2N Helios IP Configuration manual v2.6 User Manual
Page 64
64
Calls
Automatic answer – enable automatic answering of incoming calls. If this
function is disabled, the intercom signals incoming calls by ringing and the user
can answer them by pushing the * button on the numeric keypad.
Call activation – select automatic or manual microphone, speaker or camera
activation during an incoming call. The parameter is applied only if the
is enabled. If you select manual activation, enter the
Automatic Answer
activation code, see below.
Activation code – enter the call activation code via the IP phone numeric
keypad to activate the microphone, speaker and camera if available. The
parameter is applied only if the manual call activation is enabled.
Ring time limit – set the outgoing call setup and ringing time limit after which
the calls shall be automatically terminated. If the calls are routed to the GSM
network via GSM gateways, your are advised to set a value higher than 20 s.
Call time limit – set the call duration limit after which the call is automatically
terminated. The intercom signals termination with a beep 10 s before the call
end. Enter any DTMF character into the call (# on your IP phone, e.g.) to extend
the call time.
Dial cycles limit – set the maximum count of user deputy dial cycles if the user
dialled by the Phone Book position number is inaccessible. The function helps you
avoid deadlock if the
is set to the same value in the Phone Book.
User Deputy