2N VoiceBlue MAX v1.3 User Manual

Page 86

Advertising
background image

86

2N TELEKOMUNIKACE a.s., www.2n.cz

®

netid – network ID of active wireless network
oper – name of active wireless network
new – number of received and saved MS on SIM card
cnt – total number of sent SMS messages according to statistics

*smsinc: ch,ix,sts,mem – SMS message has been received and saved

ix – index number of saved SMS (0-250)
sts – status of SMS (from +CMGL: ix.sts.len)
mem – type of used storage (1,2,3)

*smsrep: ch,ix,sts,mem – SMS status confirmation has been received

sts – reserved (0)

*smsout: ch[/id],ref,req – SMS message was sent and not saved to SIM card

ref – reference number of SMS (0-255) – to be used in status confirmation
messages
ID – third party identification number of SMS

*smspdu: ch,ix,sts,len,pdu,csum – Content of SMS message

len – length of SMS message (number of bytes in PDU)PDU – content of
message in PDU format
csum – checksum of all PDU bytes (2 hexa digits) calculated without carry

*smsdel: ch,ix – SMS message deletion confirmation
*smserr: ch[/id],ix,req,err,cms – Fault command response, or SMS not sent

req – required wireless engine or GSM group
err – error code (6-busy,40-write,41-read,42-delete,43-list)
cms – error cause from wireless engine

*smssel: ch,cnt – SMS storage change confirmation
AT^SX=ch – SMS listing - request for listing of all SMS messages and status
confirmations saved on SIM card. Possible answers:: *smserr (busy,list) or
*smsinc (ix=1..255) for each saved SMS or status SMS , end of list or empty SIM
card - *smsinc (ix=0).
AT^SR=ch.ix – SMS read - request for reading of an SMS message or SMS
status saved on SIM card. Possible answers: *smserr (busy,read) or *smspdu
AT^SD=ch,ix – SMS delete - request for deletion of an SMS message (or SMS
status message). Possible answers: *smserr (busy,delete) or *smsdel
AT^SM=ch,len,pdu,chsum – SMS to module - request for sending a message
via GSM module 0..31 or via any GSM module (ch=32). Possible answers:
*smserr (busy,write) or *smsout
AT^SG=grp[/id],len,pdu,csum – SMS to group - request for sending an SMS
message via GSM group 1..8. Possible answers: *smserr (busy,write) or *smsout
AT^SS=ch,mem – Command for changing SMS storage. Mem (1;2;3) = type of
SMS

,

2=ME,

3=MEEricsson:1=SM,

2=ME,

storageSiemens:1=SM

3=MEWavecom:1=SM,

2=ME,

3=SR

Huawei:1=SM,

2=SM,

3=SMSierraWir.:1=SM, 2=ME, 3=SRMotorola:1=IM, 2=IM, 3=IM

Advertising