Brother HL-3260N - Manual (Page 120)

USER’S GUIDE
3-36
!
List of Factory settings
The following table shows the factory settings initially set before shipment.
✒ ✒ ✒ ✒
Notes
•
The settings are subject to the emulation mode. Effective modes are
indicated in parentheses in the following table.
•
The following settings cannot be restored to the factory settings with the
RESET menu in the “FACTORY SETTINGS” mode: INTERFACE MODE,
HRC SETTING
, PAGE PROTECTION, SCALABLE FONT, LOCK PANEL,
PAGE COUNTER and local language for display messages.
•
The COPY setting is always restored to the factory setting when the
printer is turned off and on again.
• It is not possible to reset NETWORK settings from the Control panel. If
you need to reset the Network card, press the Test button on the rear of
the Network board (NC-4100h) more than 5 seconds.
M M M O O O D D D E E E M M M E E E N N N U U U F F F a a a c c c t t t o o o r r r y y y S S S e e e t t t t t t i i i n n n g g g
PAPER PAPER PAPER PAPER SOURCE SOURCE SOURCE SOURCE
=AUTO
MP FIRST MP FIRST MP FIRST MP FIRST
=OFF
MP SIZE MP SIZE MP SIZE MP SIZE
=A4/LETTER
MANUAL FEED MANUAL FEED MANUAL FEED MANUAL FEED
=OFF
TRAY1 TRAY1 TRAY1 TRAY1 ✶ ✶ ✶ ✶ SIZE SIZE SIZE SIZE
=A4/LETTER
TRAY2 TRAY2 TRAY2 TRAY2 ✶ ✶ ✶ ✶ SIZE SIZE SIZE SIZE =A4/LETTER
TRAY3 TRAY3 TRAY3 TRAY3 ✶ ✶ ✶ ✶ SIZE SIZE SIZE SIZE =A4/LETTER
TRAY4 TRAY4 TRAY4 TRAY4 ✶ ✶ ✶ ✶ SIZE SIZE SIZE SIZE =A4/LETTER
DUPLEX DUPLEX DUPLEX DUPLEX =OFF
OUTPUT OUTPUT OUTPUT OUTPUT =STANDARD
JOB OFFSET JOB OFFSET JOB OFFSET JOB OFFSET =ON
QUALITY QUALITY QUALITY QUALITY RESOLUTION RESOLUTION RESOLUTION RESOLUTION =600
HRC HRC HRC HRC =ON
TONER SAVE TONER SAVE TONER SAVE TONER SAVE =OFF
DENSITY DENSITY DENSITY DENSITY =0
SETUP SETUP SETUP SETUP LOWER LCD LOWER LCD LOWER LCD LOWER LCD =NONE
POWER SAVE POWER SAVE POWER SAVE POWER SAVE =30M
AUTO CONTINUE AUTO CONTINUE AUTO CONTINUE AUTO CONTINUE =OFF
LOCK PANEL LOCK PANEL LOCK PANEL LOCK PANEL =OFF
REPRINT REPRINT REPRINT REPRINT =ON
EMULATION EMULATION EMULATION EMULATION =AUTO(EPSON)
KEEP PCL KEEP PCL KEEP PCL KEEP PCL =OFF