Brother HL-3260N - Manual (Page 198)

5-10
☛ ☛ ☛ ☛ 8.
Put the Drum unit removed in Step 6 into the plastic bag emptied in Step 7,
keeping the unit at the same angle as when it was installed. Then, seal the
plastic bag.
☛ ☛ ☛ ☛ 9.
Remove the two red sheets from the Drum unit in the order shown in the
illustration. (
① → ②)
ZAEM350E
1
2
Fig. 5-16
✒
Note
• Remove the drum unit keeping the unit parallel to the ground as shown
in the illustration, otherwise the toner in the unit might scatter.
• Do not touch the inside of the unit or the green parts after the black
protection sheet is removed.
☛ ☛ ☛ ☛ 10.
Align the new Drum unit onto the rail of the printer. Slide the unit all the way
into the printer.
ZAEM360E
Fig. 5-17