Brother HL-3260N - Manual (Page 183)

4-60
☛ ☛ ☛ ☛ 6.
Attach the printer board cover that was removed in step 2, and use a coin to
fasten the six screws.
✒
Note
• If you are going to install the hard disk at the same time, it is not
necessary to reattach the cover at this stage.
Fig. 4-99
☛ ☛ ☛ ☛ 7.
Reconnect the printer cable from your computer. Plug the power cord into
the AC outlet and turn on the printer.
☛ ☛ ☛ ☛ 8.
To check whether the DIMM has been installed correctly, you may perform a
Test Print “Print Configuration” that will print the current memory size.