Brother HL-3260N - Manual (Page 126)

CHAPTER 4 OPTIONS
4-3
O O p p t t i i o o n n I I n n s s t t a a l l l l a a t t i i o o n n S S e e q q u u e e n n c c e e
When you install options, they should be installed in the sequence
described below.
☛ ☛ ☛ ☛ 1.
Installing Lower paper tray
(LT-5100 or LT-5200)
There are two types of paper trays:
A 500x2 sheets paper tray (LT-5100) and a
2000 sheets paper tray (LT-5200)
Only one of them can be installed at any
time.
See “Installing the Lower paper tray” in
this chapter.
☛ ☛ ☛ ☛ 2.
Installing Interchange unit
(SP-5000)
The Interchange unit is used for Duplex
printing or Mailbox operation. If you intend to
install a Duplex unit or Mailbox, an
Interchange unit must be installed first.
See
“Installing the Interchange unit” in this
chapter.
☛ ☛ ☛ ☛ 3.
Installing Duplex unit
(DX-5000)
Install the Duplex Unit on the right hand side
of the printer, after installing the Interchange
Unit.
See “Installing the Duplex unit” in this
chapter.
☛ ☛ ☛ ☛ 4.
Installing Multi-purpose tray
(MP-5000)
Install the Multi-purpose tray on the right
hand side of the printer.
See “Installing the
Multi-purpose tray” in this chapter.
☛ ☛ ☛ ☛ 5.
Installing Mailbox
(MX-5000)
Install the Mailbox on top of the Interchange
Unit after installing the Interchange unit.
See
“Installing the Mailbox” in this chapter.
☛ ☛ ☛ ☛ 6.
Installing Bridge Unit
(BU-5000)
Install the Bridge unit on the standard output
tray.
See “Installing the Bridge Unit” in this
chapter.
☛ ☛ ☛ ☛ 7.
Installing Finisher/Stapler
(FS- 5050)
Install the Finisher/Stapler after installing the
Interchange unit.
See “Installing the
Finisher/Stapler” in this chapter.
✒ ✒ ✒ ✒
Notes
• If you want to install a Finisher/Stapler (FS-5050), a Bridge unit (BU-
5000) is required.
• If you want to install a Mailbox unit (MX-5000) or Duplex unit (DX-5000),
an Interchange unit (SP-5000) is required.
• If you install the optional lower tray (LT-5100 or LT-5200), only one of
them can be installed at any time.