ElmoMC SimplIQ Digital Servo Drives-Drum HV - Manual (Page 19)

Drum HV (High Voltage) Installation Guide Installation
MAN-DRU-HVIG (Ver. 1.602)
www.elmomc.com
19
3.3. Connectors
The Drum HV (High Voltage) has nine connectors.
3.3.1. Connector Types
The Drum HV (High Voltage) has the following types of connectors:
Type Function Port Connector Location
N/A N/A N
Barrel Connector +
M6 Spring Washer
+ M6 Nut Power VP+, VN-
Motor M1, M2, M3
Barrel Connector +
M5 Flat Washer +
M5 Spring Washer
+ M5 screw Ground PE, PE, PE, PE
Table 1: Power Connectors on the Drum HV (High Voltage)
Type Function Port Connector Location
15-Pin High-
Density Female
D-Sub
Connector Aux.
Feedback FEEDBACK B
(Port B)
15-Pin Female
High-Density
D-Sub Connector Main
Feedback FEEDBACK A
(Port A)
26-Pin Male
High-Density
D-Sub Connector Analog
Input and
General I/O I/O
Table 2: Feedback and I/O Connectors on the Drum HV (High Voltage)
Note: Throughout this manual FEEDBACK A and FEEDBACK B refer to the connectors labeled
Port A and Port B on the Drum HV (High Voltage) and the cables connected to them.