ElmoMC SimplIQ Digital Servo Drives-Drum HV - Manual (Page 8)

Drum HV (High Voltage) Installation Guide
MAN-DRU-HVIG (Ver. 1.602)
www.elmomc.com
8
Chapter 1: Safety Information
In order to operate the Drum HV (High Voltage) servo drive safely, it is imperative that you
implement the safety procedures included in this installation guide. This information is
provided to protect you and to keep your work area safe when operating the Drum HV (High
Voltage) and accompanying equipment.
Please read this chapter carefully, before you begin the installation process.
Before you start, make sure that all system components are connected to earth ground.
Electrical safety is provided through a low-resistance earth connection.
Only qualified personnel may install, adjust, maintain and repair the servo drive. A qualified
person has the knowledge and authorization to perform tasks such as transporting, assembling,
installing, commissioning and operating motors.
The Drum HV (High Voltage) servo drive contains electrostatic-sensitive components that can
be damaged if handled incorrectly. To prevent any electrostatic damage, avoid contact with
highly insulating materials, such as plastic film and synthetic fabrics. Place the product on a
conductive surface and ground yourself in order to discharge any possible static electricity
build-up.
To avoid any potential hazards that may cause severe personal injury or damage to the product
during operation, keep all covers and cabinet doors shut.
The following safety symbols are used in this manual:
Warning:
This information is needed to avoid a safety hazard, which might cause bodily
injury.
Caution:
This information is necessary for preventing damage to the product or to other
equipment.