Barco DCS-200 - Manual (Page 35)

DCS-200 • User’s Guide 35
4. Operation
Button States
Figure 4-4. System Initialization Message 4 (sample)
The “version” line in the above menu shows the software version that is currently installed.
This version number changes as software upgrades are released.
When you first start up a DCS-200 that has stored logos, a message like the one in the
following illustration appears during initialization:
Figure 4-5. LOGO Initialization Message (sample)
After system initialization is complete, the Status Menu appears.
_мннзе=pн~нЙл
Remember that there are three states for the buttons in the Inputs Section:
• Off — the input is not selected for a transition.
• Blinking — the blinking status depends on the type of button:
~ For an input button:
• When blinking fast, the input is being acquired by the system.
• When blinking slow, the input is ready to be transitioned to
Program.
~ For an effect button (BLACK, KEY):
• When blinking fast, the button’s “auto take” mode is ON , and
the effect is currently transitioning on or off.
• When blinking slow, the button’s “auto take” mode is OFF , and
the effect is pending for the next transition.
• Lit Solid — the input or the effect is on Program.
Remember also that when you press TAKE, the DCS-200 automatically flip-flops the
current source on Program with the “pending” source. Refer to the “
Flip-flop Mode ”
section on page 85 for additional information.
D C S - 2 0 0
B a r c o
V e r s i o n 1 . 0
I n i t i a l i z i n g . . .
L O G O 1 l o a d i n g . . .
5 %