Barco DCS-200 - Manual (Page 57)

DCS-200 • User’s Guide 57
4. Operation
Using the Setup Menu
_~ЕвЦкзмеЗ
From the Input Menu, select Background to change the system’s background color
between “Black” and “Gray.” This is a global setting.
When set to Gray, you can clearly see the edges of an input, particularly when the input’s
aspect ratio does not match the output’s aspect ratio. Note that the background selection
persists between source changes.
qáãáåÖ=^Замлн
From the Input Menu, select Timing Adjust to display the Timing Adjust Menu, which
allows for exact positioning of the input's active area.
Figure 4-24. Timing Adjust Menu (sample)
For DVI digital, NTSC and PAL videos the Timing Adjust Menu is informational only.
Because the individual parameters cannot be adjusted, they are bracketed, as shown in the
following illustration.
Timing Adjust Menu — DVI Digital, NTSC, PAL (sample
T I M I N G A D J U S T
> A u t o C o n f i g
S a m p l i n g [ 1 : 1 ]
P h a s e A [ 0 ]
P h a s e B 5
H T o t a l 2 1 6 0
H P o s i t i o n 4 9 6
H A c t i v e 1 6 0 0
V T o t a l [1250]
V P o s i t i o n 4 9
V A c t i v e 1 2 0 0
Note Timing Adjust Menu settings apply to analog input sources
only, except for NTSC and PAL sources. For digital, NTSC
and PAL sources, refer to the “
Image Adjust ” section on
page 60.
T I M I N G A D J U S T
> A u t o C o n f i g
S a m p l i n g [ 1 : 1 ]
P h a s e A [ 0 ]
P h a s e B [ N / A ]
H T o t a l [ 8 5 8 ]
H P o s i t i o n [ 1 2 3 ]
H A c t i v e [ 7 2 0 ]
V T o t a l [ 5 2 5 ]
V P o s i t i o n [ 3 6 ]
V A c t i v e [ 4 8 6 ]