Barco DCS-200 - Manual (Page 80)

80 DCS-200 • User’s Guide
4. Operation
Using the Setup Menu
You can view and change the current setting for each input by using the File Association
Menu, shown in the following illustration:
Figure 4-52. File Association Menu (sample)
When you associate a configuration file with a specific input, the file is used by any input
source connected to that input.
To change a setting, scroll to an input number and press SEL. Choose a new configuration
file and press SEL again. The change takes effect the next time the input button is
pressed.
Refer to the “ About Input Configuration Files ” section on page 63 for additional
information about setting, recalling, saving and deleting input configuration files.
qÉãéÉê~нмкЙ
From the System Menu, select Temperature to display the System Temperature Menu.
Figure 4-53. System Temperature Menu (sample)
The System Temperature Menu indicates the chassis’ internal temperature in both celsius
and farenheit. When the menu is displayed, temperature values update every 4 seconds.
Note that the DCS-200 measures the internal temperature for an “over-temp” condition
every 5 minutes. If the system’s internal temperature exceeds 122° F (50° C), the following
message appears:
Figure 4-54. Over Temperature Warning
F i l e A s s o c i a t i o n
> I n p u t 1
1
I n p u t 2 2
I n p u t 3 3
I n p u t 4 4
I n p u t 5 5
I n p u t 6 6
I n p u t 7 7
I n p u t 8 8
S D I 9
S Y S T E M T E M P E R A T U R E
T e m p e r a t u r e °F 8 5 . 8
T e m p e r a t u r e °C 2 9 . 9
O V E R T E M P E R A T U R E
C o n t a c t f a c t o r y i f
c o n d i t i o n p e r s i s t s .
E S C = C o n t i n u e