Barco DCS-200 - Manual (Page 82)

82 DCS-200 • User’s Guide
4. Operation
Using the Setup Menu
• If you do not perform the Save System State function, data will not be restored
upon the next system power up sequence.
• If you make a change in the System Menu and attempt to exit the menu (by
pressing ESC) without saving changes, the system displays the following prompt:
:
Figure 4-57. Save System Configuration Prompt
~ Select Yes (SEL) to save changes.
~ Select No (ESC) to continue operation without saving the changes.
qÉÅÜ=pìééçêí
From the Setup Menu, select Tech Support to display the Tech Support Menu:
Figure 4-58. Tech Support Menu
The Tech Support Menu displays the following information:
• Version — displays the current version of installed operating firmware. This
number changes when you update system software. In Chapter 6, refer to the
“
Software Upgrade Overview ” section on page 108 for update instructions.
• Phone — lists the technical support phone number.
c~Ензку=oÉëÉí
From the Main Menu, select Factory Reset to display the Factory Reset Menu:
Figure 4-59. Factory Reset Menu
This function enables you to reset the DCS-200 to its factory default condition, in which all
user-defined input, output and system configuration files are deleted. When the command
is executed, a confirmation menu is shown.
S a v e S y s t e m C f g ?
< S E L > = Y e s
< E S C > = N o
T E C H S U P P O R T
V e r s i o n
0 1 . 0 0
P h o n e 86 6- 3 74- 7 87 8
C l e a r A l l S a v e d
C o n f i g u r a t i o n s ?
< S E L > = Y e s
< E S C > = N o