Barco DCS-200 - Manual (Page 81)

DCS-200 • User’s Guide 81
4. Operation
Using the Setup Menu
To clear the message and continue operations, press ESC.
aб~ЦезлнбЕл
From the System Menu, select Diagnostics to display the Diagnostics Menu:
Figure 4-55. Diagnostics Menu
If you suspect a problem with the DCS-200, press SEL to run a series of internal diagnostic
tests. The menu will report back “PASS” or “FAIL.”
p~îÉ=póëíÉã=pн~нЙ
From the System Menu, select Save Config to save all current “system” settings so that
they may be restored at power up. A message is briefly shown, after which the DCS-200
returns to the System Menu.
Figure 4-56. Saving System Configuration Message
Please note the following important points regarding the system configuration file:
• When you perform the Save Config function, all configuration parameters from
the System Menu are saved in non-volatile memory. If you do not perform the
function, data will not be restored upon the next system power up sequence.
• This command also saves the current input as the default power-up selection.
Note This message is a warning only, which does not prevent the
operation of the DCS-200. If this message appears, it is
recommended that you contact Barco Customer Service.
D I A G N O S T I C S
> S E L = S t a r t T e s t s
Note If the menu reports “FAIL,” contact Barco Customer Service.
In Appendix C, refer to the “
Contact Information ” section on
page 160 for contact details.
S a v i n g S y s t e m C o n f i g . . .
Note If you want the DCS-200 to always power up and acquire an
input other than input 1, perform the Save System State
command while the desired input is selected on Program.