INFICON Helium Leak Detector Modul1000 - Manual (Page 85)

Maintenance tasks
7-13
jinb
80
e1
-h
Op
er
at
in
g M
a
nua
l
(1
01
2)
7.8 Replacing of parameter memory (I•STICK)
The customer's application parameters are also stored in I•STICK If a backup unit is
required, the application parameters can easily be transferred by connecting the
I•STICK to the backup unit.
Required Tools
• Allen key SW 8
• Screwdriver size 1
Required material
• I•STICK
Access to the I•STICK is only possible when the cover of the Modul1000 has been
removed. Follow the instructions in
7.5.1 Opening of the Device .
Notice: Please observe the safety instructions in this chapter.
• To replace the I•STICK, release the two screws with which the I•STICK is
screwed on the connector. See the
Fig. 7-7 below.
After the screws have been released, pull the I•STICK out of the socket and insert
the I•STICK of the defect device.
The installation is performed in reverse order.
Fig. 7-7 I•STICK replacement
Item Description Item Description
1 I•STICK 2 Fixing screws
1
2