INFICON HLD6000 Refrigerant Leak Detector - Manual (Page 19)

4 Description
19
Tr
an
sl
ation
o
f the
o
rig
in
al
operatin
g
in
str
u
ct
io
ns
HLD
6000
, k
ina4
3
e1-
a
, 140
8
Error information operator No. and text
Error information supervisor No., text and info
Filter change request On
Gas in the SMART sniffer line R134a
I/O module protocol ASCII
Interval for auto standby 2 min.
Interval for calibration request 60 min.
Calibration factor 15.0 (Calibration factor during initial setup. The calibration
factor cannot be reset to factory settings. It can be changed
by the service team.)
Config. Analog output 1 Leakage rate linear
Config. Analog output 2 Leakage rate linear
Configuration PLC Output 1 Setpoint 1 (inverse)
Configuration PLC Output 2 Setpoint 2 (inverse)
Configuration PLC Output 3 Open
Configuration PLC Output 4 Open
Configuration PLC Output 5 Measuring
Configuration PLC Output 6 Error (inverse)
Configuration PLC Output 7 CAL request (inverse)
Configuration PLC Output 8 Open (inverse)
Configuration PLC Input 1 No function
Configuration PLC Input 2 No function
Configuration PLC Input 3 Start/Stop (inverse)
Configuration PLC Input 4 No function
Configuration PLC Input 5 CAL external
Configuration PLC Input 6 No function
Configuration PLC Input 7 Delete
Configuration PLC Input 8 No function
Configuration PLC Input 9 No function
Configuration PLC Input 10 No function
Volume 5
LR setpoint 1 5.0 g/a
LR setpoint 2 10.0 g/a
Display measured value On
Module on the M12 socket I/O
Phase 20 (Phase during initial setup. The phase cannot be reset to
factory settings. It can be changed by the service team.)
Calibration leak external 10 g/a
Interface unit leakage rate g/a
Sniffer light alarm config. Flashing
Sniffer light brightness 4
Probe key configuration Setpoint
Setpoint audio alarm Setpoint
Record interval 500 ms
Memory location USB
Table 3: General factory settings (Contin.)