INFICON HLD6000 Refrigerant Leak Detector - Manual (Page 53)

6 Operation
53
Tr
an
sl
ation
o
f the
o
rig
in
al
operatin
g
in
str
u
ct
io
ns
HLD
6000
, k
ina4
3
e1-
a
, 140
8
6.8.3 Updating the software of the sniffer line
The software on the HLD6000 sniffer line can be updated from the basic unit provided that
the sniffer line is connected and works perfectly.
The software is included in the file named "Flash_HLD6000_Probe_Vxx.xx.xxx.bin".
1 Copy the file into the main directory of a USB stick.
2 Connect the USB stick with the USB port on the device.
3 Select " > Update > Sniffer Line".

The display shows information on the current and the new software as well as on the
current boot loader.
4 Check the version information.
5 Select the "Start" button to start the update.

Do not switch off the device and do not remove the USB stick whilst the software is be-
ing updated!
6.8.4 Updating the software of the I/O module
The software on the I/O module can be updated from the HLD6000 provided that the I/O
module is connected and works perfectly.
The software is included in the file named "Flash_IO1000_Vxx.xx.xxx.bin".
1 Copy the file into the main directory of a USB stick.
2 Connect the USB stick with the USB port on the device.
3 Select " > Update > I/O Module".

The display shows information on the current and the new software as well as on the
current boot loader.
4 Check the version information.
5 Select the "Start" button to start the update.

Do not switch off the device and do not remove the USB stick whilst the software is be-
ing updated!
6 Follow the instructions on the touch screen and wait until the update is complete.

The following tips are shown after selecting the "Start" button on the touch screen:
– Connect and switch on the IO1000.
– Activate boot mode (switch DIP S2.3 on and off once).
– When the STATUS LED flashes green, press OK.
6.9 Switching off the device
You can switch off the device at any time with the mains switch. The parameters set in the
device remain saved.