INFICON Cygnus Editor Software Manual User Manual
Page 25
2 - 5
IP
N 07
4-
39
4-
P1
A
Cygnus Editor Operating Manual
Refer to
Figure 2-9 on page 2-7
and the text accompanying it for information on
Check for at most “n” Controllers and Max Controller Address.
When initial Autodetect changes are finished, click Finish to accept the settings
(or Cancel to abort the action). If AutoDetect was selected, the program will
automatically detect and bring online any controllers connected to the ports. A
short delay may occur while bringing the controllers online.
When the Finish button is selected, the display returns to the Port Settings tab of
the System Properties display. (See
Figure 2-6
.)
Figure 2-6 System Properties: Port added
The port type and properties can be changed when controllers are offline by
clicking the Properties button on the Port Settings page. Clicking the Properties
button will display the Com Properties page with either three tabs, for RS-232, or
two tabs for GPIB.
The first page that appears for RS-232 is shown in
Figure 2-7
and described in
.