INFICON Cygnus Editor Software Manual - Manual (Page 67)

4 - 5
IP
N 07
4-
39
4-
P1
A
Cygnus Editor Operating Manual
Data can also be saved by pressing the Snapshot toolbar button, which only saves
the data showing on the display at the time it is pressed. For example, if 3 hours of
data have been collected and the X-axis is set to show 5 minutes of data, then
pressing the Snapshot button will only save that specific 5 minutes of data. Taking
a Snapshot does not close the current data file and does not stop data collection.
NOTE: No dialog is shown when a Snapshot is saved. However, the path and
filename are displayed in the Status Bar at the bottom of the screen.
NOTE: A Snapshot can be taken of Live or Recalled data.
The maximum file size allowed for any data file is 21MB. It is the responsibility of
the user to manage data files, data archiving and hard disk storage.
4.2.2.3 The Display Smoothing Setting
The effective noise of the displayed data can be filtered by changing the
Smoothing setting(
Figure 4-7 ). Smoothing provides an averaging of data points
before the point is displayed but has no impact on the raw data collected and
saved. Smoothing only affects the display of Rate or Rate Deviation.
Figure 4-7 Changing the Smoothing
4.2.2.4 The Material Status Grid
The Control Panel also contains a status grid, which displays the Material name
in use on each channel, the Crystal Life (in percent) and the Activity. This grid is
static but can be updated at any time by pressing the Update Status button shown
in
Figure 4-8 . The Material Name can be entered in the Name column by clicking
on the default name shown (e.g. Material 1), deleting it, and entering a new name.
Figure 4-8 Materials Status Grid