Igure, Ower, Witch and – INFICON Maxtek PM-700 Plating Monitor User Manual
Page 14: Ac c, Onnector, Ront, Anel, Ndication, Irst
PM-700 SERIES PLATING MONITOR
6
Figure 1 Power Switch and AC Connector
You may see an E FAIL or I FAIL message for a short time, this is normal.
However, if the display stops on either of those messages, an internal fault has
been detected and the monitor will remain inoperative until the fault has been
corrected. Further details of error messages can be found in the Troubleshooting
Section on page 63.
Figure 2 Front Panel Indication, First Power-On
Press the Stop button to clear the P FAIL message. Now, an O FAIL will be
flashing. The red light in the Probe Status window will be on indicating a probe
failure, because there is no probe with crystal has been connected to the monitor.
Note that during actual operation, a P FAIL message indicates the line power to