INFICON Maxtek PM-700 Plating Monitor - Manual (Page 39)

PM-700 SERIES PLATING MONITOR
31
Mode Allows for selection of one of
the three measuring modes
listed in the Minimum
column. For detail description
of these modes, refer to
Monitor Measurement Modes
section. Note that this
parameter is only available in
the dual probe models. Altrntng
Dual
ProbSwap Probe Swap
Sets the monitor to perform
probes swapping
automatically or manually.
Swapping Probes section
offers a detail description of
the Probe Swap feature. This
parameter is available only in
the dual probe models. Note
this parameter will be hidden
if the Measure Mode
parameter is set to Altrntng or
Dual.
Manual Auto Manual