Computer connection, Igure, 12 t – INFICON Maxtek PM-700 Plating Monitor User Manual
Page 55: Ypical, Rs-232 i, Nterface, Able, 6 rs-232 c, Onnector, Ssignments
Advertising
PM-700 SERIES PLATING MONITOR
47
4.8.4 Computer
Connection
A 9 pin, D shell, male connector (IBM AT type) is provided as an RS-232 serial
port. A standard 9 pin female to female RS- 232 cable is used to interface
between the Plating Monitor and a host computer. To minimize Electromagnetic
Interference, a shielded cable should be used. RS-232 connector pin assignments
are listed below.
Table 6 RS-232 Connector Pin Assignments
Pin No.
Numonic
Input/Output
Description
1
Not used
No connection
2 TX
Output
Transmit
data
3 RX
Input
Receive
data
4
Not used
No connection
5 GND Ground Signal
ground
6
Not used
No connection
7
CTS
Input
Clear to Send
8
RTS
Output
Request to Send
9
Not used
No connection
Figure 12 Typical RS-232 Interface Cable
Advertising