INFICON Maxtek PM-700 Plating Monitor User Manual
Page 46
PM-700 SERIES PLATING MONITOR
38
DAC
Thckness
Range
Digital to Analog Converter
Thickness Range
Establishes the full scale value
of the DAC. See Digital to
Analog Converters section for
a detail description.
0.000 Maximum
5.000
Low DAC
Rate
Low DAC Rate
Establishes the lower limit of
the DAC rate scale factor.
See Digital to Analog
Converters section for further
details.
0.000 High
rate
minus 10
0.000
High DAC
Rate
High DAC Rate
Establishes the higher limit of
the DAC rate scale factor.
See Digital to Analog
Converters section for further
details.
Low rate
plus 10
Maximum 9.999
Simulate Simulate
Mode
Allows user to turn the
monitor Simulate Mode on or
off. For detail description of
the Simulate Mode operation,
refer to Simulation Mode
section.
On Off Off
Simulate
Rate
Simulate Rate
Defines the rate at which the
monitor will use in Simulate
Mode. Refer to Simulation
Mode section for a detail
description. Note this
parameter is hidden if
Simulate parameter is set to
Off.
0.000 999.9 0.200