Landoll SSP2101 High Capacity Sure Stand Seeder - Manual (Page 19)

ASSEMBLY INSTRUCTIONS
2-9
Pull Type Seeder
When shipped on factory trucks, seeder comes
assembled except for lights, rims, and drawbar or 3 pt.
Hitch.

CAUTION
Your exact seeder model may vary slightly from the
illustration. (Additional parts identification and location
can be obtained from reviewing parts catalog.)
IMPORTANT
If a pre-assembled component or fastener is
temporarily removed, ensure it is correctly
re-installed per these instructions.
• Check that all working parts move freely, bolts are
tight and cotter pins are spread.
• Park the seeder in a work area that has a level
surface and make sure it is blocked securely so that it
cannot roll.
NOTE
“Left” and “Right” refer to directions seen as if standing
behind the machine and facing in the direction of forward
travel.
Pull Type Seeder: Drawbar Assembly
1. Loosen hydraulic hoses from frame in area where
drawbar is to be attached.
2. Position drawbar on center of frame and secure with
four 5/8” x 6-11/16” x 5-1/2” U-bolts, lockwashers,
and nuts from bag located in seed box.
3. Fasten the hoses to drawbar with straps provided.
See Figure 2-11.
Figure 2-11: Drawbar Assembly
Do not remove rear roller arm shipping bolts until
Steps 1 thru 8 have been completed! See Figure
2-14: Shipping Bolt
U-Bolt, 5/8”
X 6-11/16” X 5-1/2”
Lockwashers, 5/8
Nut, 5/8-11
Hose Clamp
Hose
Top Plate
Clamp Pair
HHCS,1/4-20 X 1/2