Landoll SSP2101 High Capacity Sure Stand Seeder - Manual (Page 33)

ASSEMBLY INSTRUCTIONS
2-23
Coil Tine Track Remover
(Optional)
NOTE
Cannot be used with the Scraper Kit
1. Assemble the coil tines and the arm weldments to
the 1-1/2” diameter x 29” bar. The arm weldments
may be placed anywhere along the bar, but it is
suggested that they be mounted in the second hole
from the right end, and the third hole from the left
end. (Left end and right end designations are those
related to the operator when sitting in the operating
position). Mount 6 of the coil tines to the bar with 3/8”
x 2- 1/2” bolts, flat washers, lockwashers, and nuts.
2. Then mount the other two coil tines to the bar with
the 3/8” x 3” bolts, lockwashers, and nuts which also
attach the arm weldments to the bar.
3. Clamp the brackets loosely to the seeder frame,
using the U-bolts, lockwashers, and nuts. Attach the
adjusting angles to frame brackets with lockscrews.
Secure the adjusting angle from swinging with a 1/2”
clevis pin and hair pin cotter. Fasten the bar and tine
assemblies to the adjusting angles with 1/2” x 1-3/4”
bolts and locknuts. Tighten the locknuts to allow free
side to side swinging. Center the entire wheel track
leveler behind the tractor tires. Tighten the U-bolts
against the seeder frame. See Figure 2-30.
4. Attach the chains’ end links to the adjusting angles
with 3/8” x 1-1/4” bolts, flat washers, lockwashers
and nuts. There is one chain for the left side and one
chain for the right side.
The vertical position can be changed by removing the
clevis pins and lock screws and moving the adjusting
angles up or down.
To inactivate the tines, remove the 1/2” clevis pins and
loosen the lock screws. Then swing the bar and tine
assemblies upward and sideways. To hold in place, wrap
the chain under the bar and place the chain into the slot
in the adjusting angle. Re-tighten the lock screws.
Figure 2-30: Coil Tine
Bar & Tine Assembly
the bar and place
Clevis Pin,1/2”
Lock Screws
Wrap the chain under
the chain into the slot.
Bar & Tine Assembly
the bar and place
Clevis Pin,1/2”
Lock Screws
Wrap the chain under
the chain into the slot.