Landoll SSP2101 High Capacity Sure Stand Seeder - Manual (Page 35)

3-1
Chapter 3
Operation
Seeder Operation
This chapter will cover basic operation and procedures
for the Landoll Brillion Alfalfa Seeder. Be sure to read and
understand the Safety Procedures and Cautions starting
on See Page 1-1.
Transport Lock (Pull Type Seeders
Only)
To prepare machine for transport:
Raise the machine fully and pin transport lock in place on
each lift cylinder.
For field operation:
Disengage each transport lock and replace the pin. See
Figure 3-1.
IMPORTANT
If the pin is not installed, the transport lock may
bounce up and cause significant damage to the
cylinder and fittings.
Figure 3-1: Transport Lock

WARNING
Be sure to observe the following sequence:
If seeder is to be unhooked with rollers on the ground, do
one of the following two things to assure proper balance.
• Lower tires to the ground, holding them hydraulically or
• Install a 5/8” x 2 1/2” bolt and nut in the “shipping” bolt
position as shown. See Figure 3-2.
NOTE
Be sure to remove bolt after seeder is reattached to
tractor so rear rollers can float in operation.
Figure 3-2: Shipping Bolt Position
Hairpin Cotter
Lock Pin
Wheel Arm
Transport Lock
Failure to follow this procedure will result in a
rapid rise of drawbar to approximately 5 1/2 feet.
Shipping
Bolt