Landoll SSP2101 High Capacity Sure Stand Seeder User Manual
Page 24
2-14
1P126
ASSEMBLY INSTRUCTIONS
NOTE
12 foot pick-up model is shown, drawbar model similar.
1.
Attach both Red LED’s to the ends of the light bar
using (4) 1/4-20 x 1 1/4 Screws and Locknuts for
each lamp.
2.
Attach Amber LED’s to the outer ends of the
seedboxes using (4) 1/4-20 x 1 1/4 Screws and
Locknuts.
3.
Attach the Light Module to the Module Bracket using
(2) 1/4-20 x 1 1/2 Screws and Locknuts. See
Figure 2-18.
4.
Layout the Lamp Harness, noting that the connectors
marked with Green Tape is Right Side and Yellow
Tape is Left Side.
5.
Plug the Lamp Harness into the Light Module, route
the plugs with Green Tape along the front right side
of the frame up the outer end of the seedbox and
plug the 2 prong cord into the Amber LED. Route the
3 prong cord up the right hand side of the Light
Bracket and plug into the Red LED.
6.
Repeat for the Left Side (Yellow Tape).
7.
Plug the 7 Pin Harness into the Light Module, then
route the harness along the 3 Pt. Hitch.
8.
Bundle and secure excess cord to the Module
Bracket with Tie Straps. Secure cords along frame
and 3 Pt. Hitch using Adhesive Mounts and Tie
Straps.
NOTE
If equipped with electrical clutch, install, route and secure
electric clutch wire harness with the warning light
harness.
IMPORTANT
All wires must be firmly attached to machine frame
members or hydraulic lines so they do not sag or
become torn loose by field debris.
9.
Attach the SMV sign to the SMV Mount located on
the center on the Light Bar (12’ Model Only) using (2)
5/16-18 x 1” Screws, Flat Washers, and Locknuts.
10. Attach the Plug Holder to the 3 Pt. Hitch using (2)
1/4-20 x 1 Screws, Flat Washers, and Locknuts.
NOTE
The plug on the other end of the 7 Pin harness connects
to the tractor socket when in use. When not in use, it can
be stored in the Plug Holder on the 3 Pt. Hitch. Allow
enough harness length to reach tractor socket and roll or
fold up excess and secure hydraulic hose or 3 Pt. Hitch.
Figure 2-18: Light Module and Bracket
MODULE
BRACKET
LIGHT MODULE
LOCKNUT,1/4-20
SCREW,
1/4-20 X 1-1/2