Landoll SSP2101 High Capacity Sure Stand Seeder - Manual (Page 28)

2-18 1P126
ASSEMBLY INSTRUCTIONS
Pick Up Seeders: Hitch
Assembly
1. Position the 3 point hitch weldment on the center of
frame and secure with four 5/8” x 6-11/16” x 5-1/2”
U-bolts, lockwashers and nuts from bag inside seed
box. See Figure 2-24.
Figure 2-24: 3 Point Hitch Assembly
2. Remove the 5/8” shipping bolt from right side of
frame which locks rear roller down. Bolt is located in
a position similar to parking pin. See Figure 2-14.
Figure 2-25: SMV Sign

CAUTION
3. Install the Warning Lamps and Wiring Harness. See
Figures 2-16, 2-17, 2-18 and 2-19 for correct
installation per machine size.
NOTE
If the bracket for the SMV sign has been shipped loose,
attach it as shown using 3/8” x 1 1/4” bolts, washers, and
nuts provided.
U-Bolts,5/8
Lockwashers,
Nuts
Shipping Bolt
Parking Pin
Front Seedboxes
Do not disengage the pin unless seeder is fully
attached to the tractor. Seeder may be rear-heavy
and tip backward on frame.