Leica Biosystems CM3050 S - Manual (Page 26)

26 Instructions for Use V 1.7 RevC - 08/2014
5.2 Switching on/fuses
Switching on
• To switch on the instrument, place switch (1)
in upper lock-in position.
Mains switch / automatic cutout for the instru-
ment:
In addition to its function as ON/OFF switch,
switch (1) is also the automatic cutout for the
instrument.
If the automatic cutout has been triggered (e.g.
caused by overcurrent):
• Put switch (1) back in upper lock-in position.
1 (Combination Mains switch /
automatic cutout for the
instrument)
2 (Automatic cutout for
sectioning motor)
Automatic cutout for sectioning motor:
The instrument is equipped with an automatic
cutout (2) for the sectioning motor.
If the sectioning motor is overloaded (e.g. when
sectioning extremely hard specimens etc.) the
automatic cutout (2) will be triggered.
To make the instrument functional again after
the automatic cutout (2) has been triggered:
• Push automatic cutout (2) inwards until it
locks into position.
5. Operation