Leica Biosystems CM3600 XP - Manual (Page 20)

20 Instructions for use, 6v3, RevB – 01/2013
3. Safety
3.1 Safety notes
This Instructions for use contains important in-
structions and information regarding the opera-
tional safety and maintenance of the instrument.
The Instructions for use is an important part of
the product, and must be read carefully prior to
startup and use and must always be kept near
the instrument.
If additional requirements on acci-
dent prevention and environmental
protection exceeding the scope of
this Instructions for use are imposed
by laws/regulations of the country
of operation, this Instructions for
use must be supplemented by ap-
propriate instructions to ensure
compliance with such
requirements.
The safety and caution notes in this chapter must be observed at all times.
Be sure to read these notes even if you are already familiar with the operation and use of
other Leica products.
This instrument has been built and tested in
accordance with the safety requirements for
electrical equipment for measurement, control,
and laboratory use.
In order to maintain this condition and ensure safe
operation, the operator must observe all the
instructions and warnings contained in this
Instructions for use.
The protective devices located on the instrument and the accessories must not be
removed or modified. Only qualified service personnel authorized by Leica may repair
the instrument and access its internal components.
3.2 Warnings
The safety devices installed in this instrument by the manufacturer only constitute the basis for
accident prevention. Operating the instrument safely is, above all, the responsibility of the owner,
as well as the designated personnel who operate, service or repair the instrument.
To ensure trouble-free operation of the instrument, make sure to comply with the following
instructions and warnings.
For current information about appli-
cable standards, please refer to the
CE declaration for the instrument on
our Internet site:
http://www.LeicaBiosystems.com