Lenze EPM Programmer EEPM1RA - Manual (Page 18)

16 ENGLISH
Operation
4.11 Create a new file
With this function you create a new parameter file in the EPM programmer. Data for your new file can be copied from the
following sources:
• Parameter files available on the EPM programmer.
• Parameter file from an EPM mounted in the MASTER PORT.
Press The display shows... Explanation
1.
MENU
CREATE NEW FILE Press the key until the menu appears in the display.
2.
ENTER
ENTER FILE NAME This request is briefly shown in the display
NAME:=_ _ _ _ _ _ _ The cursor is positioned under the first character
of the file name.
A file name can consist of 8 characters maximum.
3. NAME:A_ _ _ _ _ _ _ Use the buttons to select a value. To scroll
quickly to a value, keep the key pressed. The scroll
rate increases as you hold the button.
4.
ENTER
NAME: A=_ _ _ _ _ _ The cursor is positioned under the next character
of the file name.
5. NAME: ABC=_ _ _ _ Repeat step 3. until the desired name is entered.
6.
ENTER
NAME: ABC_ _ _ _ =
COPY DATA FROM..
Press ENTER until the cursor is positioned on the
eighth character position. If you re-press ENTER,
the file name is stored.
Press MENU at any time to abort the file creation
and return to the main menu.
7. 1) FIL E The cursor is blinking in the display on the right.
Select a source (e.g FILE) whose parameters you
want to copy into your new file:
1) FILE
2) MASTER
8.
ENTER
SELECT FILE (this message is not displayed when selecting
MASTER and steps 8 and 9 are skipped)
>#DEFAULTS(400 ) < The cursor is blinking in the display on the right.
9. >#ABC_ _ _ _ _(400 ) < Select a parameter file you want to copy
(e.g. ABC_ _ _ _ _). Press the MENU key, if you
want to abort this proceedure.
10.
ENTER
TRANSFERRING 100% The new file has been created.
FILE CREATED!
CREATE NEW FILE The EPM programmer automatically returns to the
main menu.