Lenze E94AZPS - Manual (Page 35)

Mechanical installation
Mounting steps
3
l
35 EDK94ZPS113 DE/EN/FR/ES/IT 4.0
3.2 Mounting steps
Proceed as follows for the installation:
1. Prepare M5 threaded holes on the mounting plate according to the
mounting grid.
2. When using footprint filters: Screw installation backplane and footprint
filter together.
– Use screw and washer assemblies M5 x 20 mm or hexagon socket
screws M5 x 20 mm with washers.
– Tightening torque: 3.4 Nm (30 lb−in)
3. Screw the installation backplane or footprint filter with installation
backplane onto the mounting plate. Do not yet tighten the screws.
– Use M5 screw and washer assemblies or M5 hexagon socket screws
with washers.
– The screw joint in the installation backplane may jut out no more
than 7 mm.
4. Repeat steps 2 and 3 with further installation backplanes which are
mounted side by side.
5. Align all installation backplanes.
6. Screw all installation backplanes/footprint filters onto the mounting
plate.
– Tightening torque: 3.4 Nm (30 lb−in).