Lenze EPM-H510 - Manual (Page 73)

Maintenance
L
73 EDBEPM-H510 DE/EN/FR 4.0
7 Maintenance
7.1 Maintenance
! The keypad is free of maintenance if all application conditions described in these Instructions
are observed. (% 46)
! Clean the keypad with denatured ethyl alcohol.
– If you use any other cleaning agents, please observe the information given in the table in
chapter 8.1. (% 75)
7.2 Battery replacement
! An integrated battery ensures that the recipe data, system time/data and contrast settings
remain stored when the keypad is disconnected from the voltage supply.
! Battery data:
– Lithium battery 3 V,
∅ 19 mm (CR2032)
– Order number: EPZ-H600
# # # #
Stop!
!
Switch off the voltage supply before opening the housing!
! The battery must be replaced within 30 minutes to avoid data loss.
Take off the housing cover
0
0
1
N.C. CAN+ Shield CAN- V-
1 2 3 4 5
1
2
3
4
INPUT VOLTAGE: 18-32 VDC 15 W
FUSE 800 mA
3 V LITHIUM CELL TYPE CR2032
LCD brightness adj.
MSP
+24 VDC
0 VDC
1
2
3
4
N. C.
h510_008
Fig. 7-1 Take off the housing cover
1. Remove terminal strips '
2. Loosen screws and & remove housing cover
Show/Hide Bookmarks