Lenze EDK71MMXXX−020 - Manual (Page 103)

Commissioning
Without hand terminal
7
EDK71MMXXX−020 DE/EN/FR 5.0
103
L
)
Note!
l Adhere to the switch−on sequence.
l In case of faults during commissioning, the chapter on "Troubleshooting"
provides support (
^ 133).
Switch−on sequence Comment
1. Ensure that the starttec is inhibited
after mains switch−on Terminal X3/28 = LOW
2. Switch on mains
3. Switch on 24−VDC supply
4. Release starttec Terminal X3/28 = HIGH
5. Release brake, if necessary Terminal X3/E3 = HIGH
6. Start the drive
C 2 motors
Start motor 1 Terminal X3/E1 = HIGH
Start motor 2 Terminal X3/E2 = HIGH
CINH
E1
E2
M1
M2
E3
t
tir tir tif tif
start231
CINH Release starttec via X3/28
E1 Start motor 1
M1 Voltage characteristic at
X1/1U, 1V, 1W (motor 1)
E2 Start motor 2
M2 Voltage characteristic at
X1/2U, 2V, 2W (motor 2)
E3 Brake control at X1/B1, B2
t ir Acceleration time
t
if
Deceleration time 0.5 s
(C0013)
D Reversal of direction of
rotation
Start motor Terminal X3/E1 = HIGH
CW rotation Terminal X3/E2 = LOW
CCW rotation Terminal X3/E2 = HIGH
start233
CINH
E1
E2
M1
M2
CW
CCW
t
tir tir tir tif
CINH Release starttec via X3/28
E1 Start motor
E2 Reverse direction of
rotation
M1 Voltage characteristic at
X1/1U, 1V, 1W (motor 1)
M2 Voltage characteristic at
X1/2U, 2V, 2W (motor 2)
CW CW rotation
CCW CCW rotation
t ir Acceleration time
t if Deceleration time 0.5 s
(C0013)
7. The drive is now running