MK Diamond MK-370 EXP - Manual (Page 21)

EXTERNAL WATER SOURCE
This is the preferred method of cooling.
21
WATER PUMP SETUP FOR OPERATION
The Water Pump can be setup for operation in two ways: External Water Source or Re-circulation.
RE-CIRCULATION
When using the re-circulation method, the water should be changed often for longer pump life
(A)
Ensure that Cooling Transfer
Tube is connected
(D)
Fill the Water Pan until water
completely covers the Water
Pump suction
(B)
Place the Water Pump toward
the back of the Water Pan
MK-370EXP SAW SETUP
(C)
Position pump as shown and
place the pump electrical
cord and cooling transfer tube
under the frame.
If cutting dry DO NOT connect the water pump.
1. Verify or remove the Drain Plug from the Water Pan.
2. Place the Water Pump in an external container.
3. Fill the external container until water completely covers the Water Pump suction inlet.
4. Place an external catch basin below the Water Pan drain hole.
NOTE:
NOTE: