MK Diamond MK-370 EXP - Manual (Page 33)

33
When installing the Retaining Nut, do not “cross-thread" and DO NOT over tighten the screw.
DIAMOND BLADE CHANGE-OUT
(B)
Remove Retaining Nut and
Outer Flange
(A)
Open the Outer Blade
(C)
Remove Diamond Blade
from Blade Shaft
(E)
Install the Retaining Nut
and Outer Flange and then
tighten using the Blade and
Shaft Wrenches
(D)
Install the Diamond Blade
onto Blade Shaft
(F)
Verify the Blade is seated on
the Blade Shaft and direction
of rotation is correct
(G)
Close the Outer Blade
MK-370EXP SAW MAINTENANCE
NOTE: