MK Diamond MK-370 EXP - Manual (Page 31)

31
(K)
Lubricate the Cutting Head
Pivot Shaft
(J)
Lubricate the Cutting Head
Pivot Holes
(L)
Lubricate the Cutting Head
Adjustment Knob
(M)
Verify the Cutting Table Roller
Wheel Assembly is tight
(N)
Verify that the Roller Wheel
is tight
MK-370EXP SAW MAINTENANCE
FLOW ADJUSTMENT
If flow to the diamond blade requires adjustment, perform the following actions.
(B)
Reduce cooling flow by
pressing down on the Flow
Adjusting Clamp
(A)
Increase cooling flow by
releasing the Flow Adjusting
Clamp
NOTE: